HP2-T23 Online Practice Questions and Answers

Which statement is correct about the HP iLO Management Engine?

A. It is recharged continuously through a trickle charging process to protect data in a failed server for up to three or four days.

B. The Active Health feature in the iLO Management Engine does not monitor hardware.

C. The health driver (agent management) is the only tool for HP SIM to collect server information from the iLO Management Engine.

D. Intelligent Provisioning is one of the major features of the iLO Management Engine.

You replaced a Smart Array P812 in a ProLiant DL380 G7 storage server. What should you do next?

A. Check the FBWC charge.

B. Replace the cache module.

C. Verify that the firmware level is current.

D. Install the BBWC battery.

A customer wants to verify that all the memory DIMMs in a ProLiant Gen8 server are genuine HP. What will provide this information?

A. Windows Event Viewer

B. ROM Based Setup Utility (RBSU]

C. iLO Event Log

D. SmartMemory

From which location does Active Health collect data?

A. iLO

B. SMH

C. Event Log

D. IML

What do you need to manage and control an InfiniBand fabric?

A. Asubnet manager

B. Amezzanine connector

C. System Management Homepage

D. Version Control Agent

To boot a USB firmware memory key built by the HP USB key utility, where should an engineer insert the key to upgrade the firmware on the server blade?

A. Redundant Onboard Administrator USB connector

B. Onboard Administrator USB port

C. USB key on the server blade

D. SUV cable USB connector

An engineer is installing an HP R7000 UPS and an Extended Runtime Module (ERM) in an existing HP 10642 G2 rack. This rack contains 10 ProLiant DL380e Gen8 servers mounted from 1U upward.

How should the engineer perform this installation?

A. Mount the R7000 UPS at 10U in the 10642 G2 rack with the ERM on top of the R7000 UPS.

B. Remove the lowest ProLiant DL380e Gen8 servers and mount the R7000 and the ERM at the lowest position in the rack. Mount the removed ProLiant DL380e Gen8 servers at a higher position in the 10642 G2 rack.

C. Mount the R7000 at the highest position possible in the 10642 G2 rack with the ERM just below the UPS.

D. Remove the two lowest mounted ProLiant DL380e Gen8 servers and mount the R7000 at the bottom of the 10642 G2 rack. Mount the two removed ProLiant DL380e Gen8 servers at the top of the 10642 G2 rack. Mount the ERM above the remaining original mounted ProLiant DL380e Gen8 servers.

Which statements are correct about the HP Customer Self Repair (CSR) program? (Select two.)

A. A travel and labor charge applies when customers decline to replace an optional CSR part.

B. A travel and labor charge does not apply when customers decline to replace an optional CSR part.

C. A travel and labor charge does not apply when customers decline to replace a mandatory CSR part.

D. A travel and labor charge applies when customers decline to replace a mandatory CSR part.

What is a distinguishing feature of flash-backed write cache (FBWC)?

A. It enables disk drive write cache with error checking and correcting (ECC) flash memory.

B. It uses a fixed read-ahead caching scheme to increase sequential read performance.

C. It returns write completion status to the operating system after it writes data to the drives.

D. It uses a capacitor and flash memory to hold data rather than a battery and a DIMM.

Which memory configuration types are supported in the ProLiant Gen8 server blades? (Select two.)

A. SDIMM

B. SODIMM

C. UDIMM

D. RDIMM

E. DDR3