HP HPE2-Z39 Exam Questions & Answers

An ArubaOS switch has the routing table shown in the exhibit. A network administrator then enters this

command:

Switch (config) # ip route 10.1.8.0/24 10.1.12.8

Switch (config) # ip route 10.1.4.0/24 10.1.12.13

After the administrator enters this command, packets arrive that are destined for 10.1.12.8 and 10.1.12.13.

What does the switch do with this traffic?

A. It drops all of the traffic.

B. It forwards some of the traffic on VLAN 101 and some of the traffic on VLAN 4.

C. It forwards all of the traffic to 10.1.104.2.

D. It forwards some of the traffic to 10.1.101.1 and drops some of the traffic.

The switches in the exhibit use RSTP The network administrator needs to add Link 2. Why should the administrator configure Links 1 and 2 as a link aggregation?

A. to combine traffic statistics for the interfaces

B. to prevent a loop from occurring

C. to share traffic more evenly over both links

D. to automatically apply the settings already configured for Link 1 to Link 2

An Aruba Virtual Switching Framework (VSF) fabric has 10GbE interfaces assigned to its VSF link. The

network administrator wants to change the link to use 40GbE interfaces.

Which procedure follows the best practices and requirements to set up the VSF links?

A. Create an LACP link aggregation on the 40GbE interfaces, and then add them to the VSF link.

B. Shut down the standby member, remove the VSF link, and then re-create the link with only 40GbE interfaces.

C. Create a second VSF link that uses the 40GbE interfaces, and then remove the first VSF link.

D. Add the 40GbE interfaces to the VSF link, and then remove the 10GbE interfaces from the link.